IBM C2010-576 問題集

質問 1：
A service provider has a requirement to be non-disruptive during configuration changes. They are considering implementing SmartModel.
What would be two reasons for choosing this option?
A. It optimizes the device configuration and provides better performance on the device.
B. It allows faster configuration of a device.
C. It automatically adjusts the performance settings on the device based on the configuration changes and reduces the risk of failure or performance decline.
D. It allows a configuration rollback without a reset or reboot of the system.
E. It allows users to test a command set in Report Only mode against devices without implementing them to ensure that the outcome is as intended.
正解：B,D

質問 2：
A customer has requested that a document be produced detailing the potential topology/technology issues with the proposed Tivoli deployment. Assuming all the relevant customer contacts are in place, which two types of information should be collected from the customer regarding their current topology?
A. a listing of all the DNS servers in the network
B. all relevant vendor documentation for the devices to be managed
C. a listing of all the elements to be managed (routers, interfaces, vendor, type model, operating system)
D. a listing of all the IP addresses for the devices to be managed
E. a list of all users accessing the devices
正解：C,E

質問 3：
A large IT outsourcing company that manages networks for commercial customers is particularly concerned about High Availability and disaster recovery.
What is an important consideration for the customer when planning where the network management components will be deployed?
A. The disaster recovery components should be deployed in a data center physically close to the primary site so that operators can commute to the backup site.
B. The disaster recovery components should be deployed in a location physically distant from the primary site.
C. The disaster recovery components must be deployed in the same time zone as the primary site.
D. The disaster recovery components should be deployed in the same data center as the primary site.
正解：A

質問 4：
What are burst thresholds as defined in IBM Tivoli Netcool Performance Manager DataView reports?
A. BURST = Best Utilized Resource Specific Timelnterval. It is a resource that has the highest value during a specific time for a specific metric.
B. Burst thresholds are derived from static thresholds and specify the number of violations during the static interval.
C. Burst threshold are evaluated against a group of resources rather then a single resource.
D. These are thresholds that ignore the natural network bursts by evaluating how long consecutive violations occurred per resource.
正解：D

質問 5：
What is a valid user authentication method that could be used as a standard authentication mechanism across all Tivoli Network and Service Assurance products?
A. biometric
B. NT-LAN Manager
C. LDAP
D. two factor authentication
正解：A

質問 6：
What is the difference between Tivoli Common Reporting/Cognos (TCR/Cognos) reports and DataView reports in the IBM Tivoli Netcool Performance Manager Wireline Component product?
A. TCR/Cognos reports are static; DataView reports are dynamic.
B. TCR/Cognos reports are dynamic; DataView reports are static.
C. TCR/Cognos reports use raw and aggregated data: DataView reports use only raw data.
D. TCR/Cognos reports use only raw data: DataView reports use raw and aggregated data.
正解：D