Avaya 3605 問題集

質問 1：
Which protocol can be used for end-to-end detection in a network as well as for point-to-point detection?
A. MSTP
B. LACP
C. RSTP
D. VLACP
正解：D
解説: (Topexam メンバーにのみ表示されます)

質問 2：
A technician is configuring
password levels
on the Ethernet
Routing Switch (ERS) 8600, and wants the manager to be able to view and edit most device settings, but not be able to change security and password settings. Which login Level should be set for the manager?
A. Read Write All Access
B. Read-Write Access
C. Layer3Read-WnteAccess
D. Layer 2 Read Write Access
正解：B

質問 3：
Which steps are initial steps required to configure the Ethernet Routing Switch (ERS) 8600 in a clustered basic core configuration? (Choose three.)
A. configure SMLT
B. enables OSPF
C. create VLANs
D. create the IST
正解：C
解説: (Topexam メンバーにのみ表示されます)

質問 4：
An engineer needs to assign an IP address of 172 25 10.31 for out of band management of an Ethernet Routing switch (ERS) 8600 switch a subnet mask of
255.255.255.192.
Which
command line
interface (CLI) command
should the engineer use?
A. ERS8600:5# config bootconfig net mgmt ip 172.25.10.36/26
B. ERS8600:5# config bootconfig set ip 172.26.10 36/26
C. ERS8800:5 # config bootconfig set ip 172.25.10 36/27
D. ERS8600:5# config bootconfig net mgmt ip 172.25.10.36/27
正解：A

質問 5：
A technician is configuring
password levels
on the Ethernet
Routing Switch (ERS) 8600, and wants the manager to be able to view and edit device settings, but not to be able to change security and password settings. Which Login Level should be set for the manager?
A. Layer 3 Read-Write Access
B. Read-Write Access
C. Read-Write-All Access
D. Layer 2 Read-Write Accesses
正解：B

質問 6：
In a multicast
campus, when
should
the
PIM
interface in passive
mode
be configured?
A. When the ERS 8600 is used as an edge switch and is aggregating end users
B. When there are no unicast routing paths
C. When PIM control traffic must be passed
D. When more than one multicast routing protocol is in use
正解：A

質問 7：
The User interface (Ul) button on the Ethernet Routing Switch (ERS) 6500 can be used to temporarily reset a switch to the default IP address. Which two statements are true about the default IP address set via the Ul button? (Choose two)
A. The default IP address overrides the IP address currently in use by the switch stack.
B. the default IP address changes if there is a change in the state of the switch, such as if the switch joins or leaves a stack.
C. The default IP address overwrites the "configured" IP address settings that are set via console. CLI or Web.
D. the default IP address is saved in NVRAM across resets of the switch/stack.
正解：A,C

質問 8：
Refer to the exhibit.

When checking an Inter Switch Trunks (IST) configuration using the show mlt ist info command as shown in the exhibit, which IP address should be in the IP ADDRESS column?
A. The IP address of the IST VLAN on the local switch.
B. The IP address of the first IST port on the peer switch.
C. The IP address of the IST VLAN on the peer switch.
D. The management IP address of the peer switch.
正解：C