VMware VCP550 問題集

質問 1：
-- Exhibit -

-- Exhibit -
A vSphere administrator has misconfigured vMotion in such a way thatvMotion migrations are failing.
Based on the information shown, what is the cause of the problem?
A. The vMotion VMkernel ports are not labeled identically.
B. The vMotion VMkernel ports on the hosts are configured with the same IP address.
C. The vMotion VMkernel ports are using the same uplink.
D. The labels of the vMotion VMkernel ports are not identical.
正解：B

質問 2：
A vSphere administrator deleted a vApp from disk. A second administrator needs the virtual machines that were contained in the vApp.
What should the first administrator do to make the virtual machines available?
A. Undelete the vApp
B. Recover the virtual machines from Stranded Items
C. Add the virtual machines back into inventory
D. Recover the virtual machines from backup
正解：D

質問 3：
An administrator is deploying vSphere 5.5. The administrator creates a vSphere Distributed Switch, then uses Auto Deploy to deploy several ESXi hosts. After the hosts are deployed, the administrator notices that LACP packets are not being sent between them.
Which condition would cause this issue to occur?
A. The LACP setting is not enabled on vCenter Server.
B. LACP has not been configured on the Auto Deploy server.
C. The LACP installation bundle is not included in the Image Profile.
D. The LACP support settings do not exist in the Host Profile.
正解：D

質問 4：
A vSphere administrator needs to perform packet tracing from a Linux virtual machine. The virtual machine is attached to a vSphere Standard Switch configured with several VLANs.
Which approach could the administrator use to configure the network to capture all traffic from the Linux virtual machine?
A. Configure a vSphere Distributed Switch with VLAN Trunking. Connect the virtual machine to the switch and enable Port Mirroring on the port group containing the virtual machine.
B. Configure a vSphere Distributed Switch with VLAN Trunking. Create a port group and configure it with Promiscuous Mode. Connect the virtual machine to that port group.
C. Configure the virtual switch with VLAN Trunking and specify each VLANs on the port group containing the virtual machine.
D. Configure the port group containing the virtual machine for Promiscuous Mode. Set the port group to use VLAN 1.
正解：B

質問 5：
-- Exhibit --

-- Exhibit --
The virtual machine Fileserver01 shown in the exhibit can not ping anything on the Internet.
Why is Fileserver01 unable to connect to the Internet?
A. The virtual nic for Fileserver01 has a speed or duplex mismatch.
B. Fileserver01 is not on the Production network.
C. Fileserver01 does not have a reachable IP address.
D. The vSwitch1 virtual switch does not have an attached vmnic adapter.
正解：C

質問 6：
A vSphere Standard Switch is configured with two uplinks.
When adjusting the failover order of the uplinks, what are two valid states in which an administrator can place the uplinks? (Choose two.)
A. Disabled
B. Active
C. Passive
D. Unused
正解：B,D