VMware VCI510 問題集

質問 1：
Which virtual disk types are supported on an network attached storage appliance using NFS with hardware acceleration disabled?
A. Raw Device Mappings
B. Flat disk
C. Thin Provision
D. Thick Provision Lazy Zeroed
正解：C
解説: (Topexam メンバーにのみ表示されます)

質問 2：
An administrator finds that an ESXi host cannot be managed by vCenter Server.
Which logs can be reviewed using the DCUI? (Choose three.)
A. ESXi shell logs
B. Syslog
C. Config log
D. Virtual Center Agent
E. VMware HA log
正解：B,C,D
解説: (Topexam メンバーにのみ表示されます)

質問 3：
When deploying an OVF template, what file format will the resulting virtual disk be?
A. OVF
B. VSWP
C. VMX
D. VMDK
正解：D
解説: (Topexam メンバーにのみ表示されます)

質問 4：
A series of Auto Deploy ESXi 5.x hosts, which utilize vSphere Standard Switches, are unable to boot. In prior testing, all of the hosts were able to boot successfully.
Which two conditions might cause this issue? (Choose two.)
A. The DHCP server is down.
B. The DNS server is down.
C. The Hosts are unable to connect to the SAN.
D. The TFTP server is down.
正解：A,D
解説: (Topexam メンバーにのみ表示されます)

質問 5：
A user wants to receive an email notification when the virtual machine CPU usage enters a warning state and again when the condition enters a alarm state. Which two state changes must be selected to receive the appropriate notifications? (Choose two.)
A. Yellow-green state change
B. Red-green state change
C. Green-yellow state change
D. Yellow-red state change
正解：C,D
解説: (Topexam メンバーにのみ表示されます)

質問 6：
On which two vSphere elements can traffic shaping be configured? (Choose two.)
A. On a vSphere Distributed Switch for inbound and/or outbound traffic
B. On a vSphere Standard Switch port group or the entire vSwitch for inbound traffic
C. On a vSphere Distributed Switch dvPort for inbound and/or outbound traffic
D. On a vSphere Standard Switch port group or the entire vSwitch for inbound and outbound traffic
正解：A,C
解説: (Topexam メンバーにのみ表示されます)

質問 7：
Click the Exhibit button.

Based on the exhibit, what is the reason that two of the paths are marked as Stand by?
A. The other two paths were set to Active.
B. The active paths were set to Preferred.
C. The storage adapters need to be rescanned before the paths will be set to Active.
D. The path configuration is required by the attached storage array.
正解：D
解説: (Topexam メンバーにのみ表示されます)

質問 8：
Click the Exhibit button.

What does the graph in the exhibit indicate?
A. The average amount of read and write latency from the cluster to the datastore.
B. The average amount of read and write latency from the ESXi host to the SAN.
C. The average amount of read and write latency from the guest operating system to the virtual machine virtual disk file.
D. The average amount of read and write latency from the ESXi host to the datastore.
正解：D
解説: (Topexam メンバーにのみ表示されます)