IBM P6040-014 問題集

質問 1：
After completing the physical procedures required in resetting CMOS, what is the next step?
A. access the IBM Retail StoreSolutions Web site and download the latest level of BIOS
B. run the IBM Diagnostics for POS to validate the CMOS settings
C. access the IBM Retail Store Solutions Web site and download the latest drivers for any connected POSperipherals
D. run the Setup Utility and select the Load Optimized Defaults option to restore CMOS settings
正解：D

質問 2：
Which three processor characteristics are found in the IBM SurePOS 5x5 series? (Choose three.)
A. It is non-socketed.
B. It operates at 2.53GHz.
C. It has an Intel chipset.
D. It does not support multi-media applications.
E. It has an Integrated Graphics Processor.
F. It has a 533MHz frontside bus.
正解：B,C,F

質問 3：
Which statement is true about the order of steps for installing a magnetic stripe reader (MSR)?
A. 1. with a screwdriver, pop out the MSR hole plugs on the left side of the display
2.align theMSR tabs into the holes and slide down so that the MSR is flush against the display
3.route the MSR cable in the groove and attach it to the port on the rear connector panel
4.at the back of the MSR device, tighten the thumbscrew to secure it to the display
B. 1. with a screwdriver, pop out the MSR hole plugs on the right side of the display
2.align the MSR tabs into the holes and slide down so that the MSR is flush against the display
3.route theMSR cable in the groove and attach it to the back side of the display
4.at the back of the MSR device, tighten the thumbscrew to secure it to the display
C. 1. with a screwdriver, pop out the MSR hole plugs on the right side of the display
2.align the MSR tabs into the holes and slide down so that the MSR is flush against the display
3.remove the tower center cover to access the MSR connector 4.route the MSR cable in the groove on the back of the display and attach it to the connector in the center of the system
D. 1. open the bezel and remove the MSR plugs
2.with the bezel open, position the MSR tabs in the holes
3.connect the MSR cable to the connector on the operator card
4.close and secure the bezel
正解：B

質問 4：
Which three resources can be utilized for support assistance? (Choose three.)
A. IBM TechLine
B. IBM POS QuickReference Guide
C. IBM AnswerLine
D. IBMLink
E. IBM POS Support Web site
F. IBM Retail Store Solutions Web site
正解：A,D,F

質問 5：
What are three applicable precautionary steps to handling static-sensitive components? (Choose three.)
A. keep one finger on the metal frame at all times
B. once the component is removed from the anti-static bag, install it immediately
C. stand with at least one foot on ananti-static mat when installing printed circuit boards
D. wear rubber gloves to reduce static electricity and prevent cuts from the sharp edges
E. when putting down static-sensitive components, do so on top of an anti-static bag, not on the system cover or metal table
F. lessen the amount of static electricity by limiting the amount of movement
正解：B,E,F

質問 6：
What is the IBM recommended method to clean the plastic housing of the IBM SurePOS 5x5?
A. use a cleaner especially made for computer equipment and a soft cloth
B. spray glass cleaner directly on the area that needs cleaning and wipe with a soft cloth
C. spray a soft cloth with anyammonia-based cleaner
D. use a soft cloth moistened with water
正解：D