Network Appliance NS0-191 問題集

質問 1：
You just set up a new clustered Data ONTAP 8.3 environment and want to monitor volume performance.
Which two commands or products would help you accomplish this task? (Choose two.)
A. Quality of Service (QoS) commands
B. OnCommand Performance Manager
C. OnCommand System Manager
D. Syslog Server
正解：A,B

質問 2：
A customer has one storage virtual machine (SVM) that is using Fibre Channel as a protocol (FCP).
Some clients are successfully accessing LUNs on this SVM. The zoning is done by using worldwide port names (WWPNs). The customer creates a second SVM for Fibre Channel and wants to access new LUNs in this SVM from the same clients.
Which three statements are true in this scenario? (Choose three.)
A. Fibre Channel zoning does not need to be changed if the second SVM uses the same ports as the first SVM.
B. FCP must be enabled on the second SVM.
C. Fibre Channel zoning must be reconfigured for the new SVM.
D. You must map the new LUNs in the second SVM to the correct initiator group (igroup).
E. The initiator groups (igroups) from the first SVM are also working for the second SVM.
正解：A,B,E

質問 3：
Your customer using clustered Data ONTAP 8.1.2 recently had a disk drive fail. They already swapped out the failed disk for a replacement disk. They call you the next day explaining that the disk is not showing up in the spare disk pool.
In this scenario, what are two reasons for this problem? (Choose two.)
A. The replacement disk drive needs to be manually un-failed before the disk will show up as a spare.
B. Autoassign is set to on, but the disk shelves in the loop are shared between a high-availability (HA) pair, causing the disk to show up as unassigned.
C. Autoassign is turned off, leaving the disk unassigned; the customer needs to take ownership of the replaced disk before it will show up as a spare disk.
D. The disk ID needs to be removed from the failed disk registry before the disk will be seen as a spare.
正解：A,B

質問 4：
Click the Exhibit tab.

A customer is attempting to protect the source volume listed in the exhibit. They try to initialize a DP mirror relationship to the destination volume but it will not initialize as expected.
Which two settings on the destination volume are causing this problem? (Choose two.)
A. type
B. language
C. volume size
D. max-autosize
正解：C,D

質問 5：
You log in to a SnapMirror destination to review the system. Which scanner would you expect to see running?
A. blocks used summary update
B. active bitmap real management
C. deswizzler
D. container block reclamation
正解：D

質問 6：
You are preparing to implement a storage virtual machine (SVM) in a SAN configuration. You need to eliminate single points of failure and enable the system to survive component failures.
According to NetApp, what is the recommended minimum number of paths per LUN connecting to each node being used by an SVM in a cluster?
A. 2
B. 3
C. 4
D. 1
正解：D