Network Appliance NS0-159 問題集

質問 1：
Which NetApp cluster configuration requires the use of epsilon?
A. a 4-node cluster
B. a single-node cluster
C. a cluster with an odd number of nodes
D. a 2-node cluster
正解：A

質問 2：
Which three data protocols are supported simultaneously in a single storage virtual machine (SVM)? (Choose three.)
A. HTTP
B. CIFS
C. FCP
D. iSCSI
E. InfiniBand
正解：B,C,D
解説: (Topexam メンバーにのみ表示されます)

質問 3：
You want to configure a local cluster to accept SnapMirror transfers from two remote clusters. The two remote clusters have overlapping IP networks and cannot change their IP addressing scheme.
In this scenario, which action you perform to allow both remote clusters to replicate to the local cluster?
A. Configure two ONTAP subnets with distinct IP address allocations.
B. Configure network address translation (NAT) on the network.
C. Create separate IPspaces on the local cluster.
D. Configure the SnapMirror relationships as type XDP.
正解：C

質問 4：
Click the Exhibit button.

After you successfully deploy cluster CDOT93, you log in to System Manager and notice the error shown in the exhibit.
Which command must you use to correct the error?
A. storage failover giveback - node CDOT93-01
B. storage failover modify - node * -enabled true
C. storage failover modify - node * -enabled false
D. storage failover giveback - node CDOT93-02
正解：B

質問 5：
Which NetApp tool indicates whether you have applied data protection policies to all volumes?
A. Config Advisor
B. Virtual Storage Console
C. OnCommand Unified Manager
D. OnCommand Service Level Manager
正解：C

質問 6：
You want to create an SVM disaster recovery relationship for a production SVM.
When you create the destination SVM, which vserver subtype should you choose?
A. sync-destination
B. dp-destination
C. default
D. sync-source
正解：A

質問 7：
You want to create a new storage pool of SSDs to provide a performance tier for FlashPool-enabled aggregates on node1 and node2. You expect that the FabricPool aggregates on node1 will require more of the performance tier than the aggregates on node2.
Which action satisfies the requirement?
A. Use the storage pool modify command to change the parity of the RAID groups in the storage pool to RAID-4.
B. Use the storage disk reassign command to reassign disk from SSD storage pool from node2 to node1.
C. Use the storage pool reassign command to reassign storage pool allocation units from node2 to node1.
D. Use the storage pool add command to add HDDs to the FabricPool aggregates on node1.
正解：C