Nutanix NCM-MCI5.15 問題集

質問 1：
An organization is running a Nutanix Cluster based on AOS 5.10.x and VMware vSphere 6.7. Currently, the CVM network is segmented and Storage only nodes not present.
A new security project based on NSX is coming. VMware Distributed Virtual Switches are required. The administrator needs to prepare the environment for the new project.
Which step should the administrator use to initiate the project?
A. Enable Jumbo Frames to accommodate network frames
B. Manually disable CVM network Segmentation
C. Convert storage only nodes into vSphere nodes
D. Enable Nutanix Flow at the Prism Central Level
正解：A

質問 2：
An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the following considerations:
* Individual VMs will likely generate network throughputs in the range of 90-100Mbps
* Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time
* Individual VMs will communicate with only a few (one or two) remote hosts at a time
* Multicast will not be used in the environment
* The hosts are connected via two 1GbE network connections
How should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?
A. Configure bond0 as balance-tcp
B. Configure bond0 as balance-sib
C. Configure bond0 as active-backup
D. Configure bond0 as balance-lacp
正解：B
解説: (Topexam メンバーにのみ表示されます)

質問 3：
Refer to the exhibit.

An administrator creates a security policy that isolates their financial application from accessing the Internet When viewing the policy in Prism Central, several connections from the application are outbound to the Internet.
What is causing this issue with the policy?
A. The 0.0.0.0 address was not specified in the outbound rule.
B. The blocked connections are illustrated for information only.
C. The policy has been left in monitor mode instead of enforcing mode.
D. The Activate box was not checked in the rule, so it is not enforcing.
正解：C
解説: (Topexam メンバーにのみ表示されます)

質問 4：
Refer to the exhibit.

After performing ESXi to AHV conversion on a cluster, the alerts shown in the exhibit display on Prism. What should the administrator do to resolve this issue efficiently?
A. Remove the VMs. create a new Protection Domain, and add VMs to it
B. Create a new Protection Domain and add the VMs to rt.
C. Delete the Protection Domain, create a new Protection Domain, and add the VMs to it
D. Remove VMs from the Protection Domain and add them back in.
正解：D

質問 5：
In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.
The current schedule configuration is as follows:
* Repeat every 6 hours
* Local Retention Policy 1
* Remote Retention Policy 8
* Starting time 12 am
At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection.
Which strategy should the administrator use to meet these requirements?
A. From the local site, restore the VM from the local snapshot by selecting the correct snapshot.
B. From the Remote site, activate the Protection Domain, then re-protect the entity.
C. From the Remote site, restore the VM from the local snapshot by selecting the correct snapshot
D. From the local site, retrieve the correct remote snapshot, then restore the VM locally.
正解：D

質問 6：
Refer to the exhibits.
An administrator has reported that a new VM is not performing well.


After analyzing the information presented in the exhibits, which option shows the best conclusion regarding this workload?
A. VM is CPU constrained since the hypervisor cannot provide the required resources.
B. VM is Storage constrained, because the workload is waiting for storage access.
C. VM is CPU constrained because more CPU needs to be added to the VM.
D. VM is not CPU constrained, because the VM is not running, a multithreaded application.
正解：B

質問 7：
A customer has Metro Availability configured in Automatic Resume Mode between Site A and Site B What happens to VMs if Primary Site A has full network failure?
A. VMs continue to run on Site A following an automatic disable of protection domains.
B. Automatic protection domain promotion in Site B. VMs automatically restart in Site B
C. An administrator must promote protection domains in Site B for VMs to restart.
D. An administrator must unwitness in Site B and promote protection domains in Site B for VMs to restart
正解：B
解説: (Topexam メンバーにのみ表示されます)

質問 8：
An administrator is notified that a bare metal database server is down. This database server is being served storage using a Nutanix Volume Group. Upon investigating, the administrator finds that the disks in the database server that map to the vDisks in the volume group have gone offline.
What is causing this issue?
A. A CVM serving the Volume Group has gone offline.
B. The Volume Group Load Balancer has been disabled.
C. Port 3260 has been blocked in the server firewall.
D. Port 9443 is blocked in the server firewall.
正解：A