Juniper JN0-362 問題集

質問 1：
Click the Exhibit button.

You have applied the policy shown in the exhibit to the forwarding table on an MX Series device. How is traffic load-balanced?
A. per frame
B. per packet
C. per flow
D. per segment
正解：C

質問 2：
What is the Junos default router priority advertisement value for IS-IS?
A. 0
B. 32
C. 127
D. 64
正解：D
解説: (Topexam メンバーにのみ表示されます)

質問 3：
Which two characteristics describe IS-IS? (Choose two.)
A. A collection of Level 2 routers serve as the IS-IS backbone
B. Level 2 routers connect areas in an IS-IS autonomous system
C. A collection of Level 1 routers serves as the IS-IS backbone
D. A Level 1 IS routes between areas and toward other autonomous systems
正解：A,B

質問 4：
To which multicast address is a VRRP advertisement packet sent?
A. 224.0.0.22
B. 224.0.0.13
C. 224.0.0.6
D. 224.0.0.18
正解：D

質問 5：
Which two IP addresses are considered Martian addresses? (Choose two.)
A. 169.254.0.0/16
B. 192.168.0.0/8
C. 240.0.0.0/4
D. 0.0.0.0/8
正解：C,D

質問 6：
Click the Exhibit button.

Referring to the exhibit, which statement is correct?
A. Routes from 10.1.1.1 are less preferred than routes from 10.2.2.2
B. Routes from 10.3.3.3 are less preferred than the default local preference
C. Routes from 10.1.1.1 are less preferred than the default local preference
D. Routes from 10.2.2.2 are less preferred than routes from 10.1.1.1
正解：D

質問 7：
You must establish an MPLS LSP between two locations. You are required to ensure that the LSP traverses specific routers within the network.
Which solution is correct in this scenario?
A. Implement LDP and define the explicit route the LSP must follow
B. Enable traffic engineering within LDP and define the explicit route the LSP must follow
C. Implement RSVP and define the explicit route the LSP must follow
D. Enable traffic engineering within RSVP and enable the Fast Reroute feature
正解：C