Juniper JN0-1362 問題集

質問 1：
Your customer's WAN edge connects to two service providers SP-A and SP-B. The customer is advertising a single /22 subnet to both service providers through EBGP peering sessions. The customer wants to influence inbound traffic to the advertised /22 destination prefix so that it passes through SP-A when both paths are operational.
Which action meets the customer's requirement?
A. Advertise the prefix to SP-A with a lower MED value than that sent to SP-B.
B. Advertise the prefix to SP-B with an origin of unknown.
C. Advertise the prefix to SP-B with a lower MED value than that sent to SP-A.
D. Advertise the prefix to SP-A with an origin of unknown.
正解：A
解説: (Topexam メンバーにのみ表示されます)

質問 2：
What are three components of a class-of-service scheduler? (Choose three.)
A. forwarding class
B. policing rate
C. delay buffer size
D. transmit rate
E. queue priority
正解：C,D,E
解説: (Topexam メンバーにのみ表示されます)

質問 3：
Your applications are migrating from a legacy data center to an EVPN over a VXLAN-based VM environment. A few critical legacy applications not support this environment and must remain on bare metal servers and the applications must be able to access the Internet.
What must be included in the VXLAN design to satisfy these requirements?
A. SR-IOV
B. VXLAN gateway
C. nested VM capability
D. VTEP tunneling
正解：B
解説: (Topexam メンバーにのみ表示されます)

質問 4：
What are two ways to provider redundancy in a WAN design to address physical failures? (Choose two.)
A. Select products that use MC-LAG.
B. Select products that use multiple Routing Engines.
C. Select products with different types of MICs.
D. Select products with different versions of firmware.
正解：C,D

質問 5：
You are asked to provide a design proposal for a services provider's core network. The network consists of both IPv2 and IPv4 addresses and must scale up to 50 core routing devices. As part of your design, you must in redundancy and ensure that future network expansion is easily incorporated.
In this scenario, which statement is correct regarding the BGP design?
A. You must use direct interface peering for your neighbors.
B. You must separate the BGP network into multiple autonomous systems on geographic location.
C. You should use a pair of route reflectors with peering's to all other core devices.
D. You should create a full mesh of EBGP neighbors in your core.
正解：C

質問 6：
Which statement is correct about learning remote host MAC addresses when your DCI is based on EVPN?
A. Static MAC configuration on the provider edge (PE) device is perform
B. No MAC learning by the provider edge (PE) device is performed
C. Control plane MAC learning by the provider edge (PE) device
D. Data plane MAC learning by the provider edge (PE) device is performed.
正解：D

質問 7：
According to Juniper Networks, which two statements describe OoB network design best practices? (Choose two.)
A. Ensure that the management network is accessible through the production network.
B. Ensure that the management network uses a unique IP network.
C. Ensure that only console ports are used to manage devices.
D. Ensure that all users are authenticated using individual accounts and credentials.
正解：B,C

質問 8：
Which two statements are correct about Junos Space Connectivity Services Director? (Choose two)
A. It is used to design, provision, and deploy MPLS-dynamic, RSVP-signaled LSP, and static LSP services on devices.
B. It is used to provide zero touch provisioning (ZTP), which simplifies the deployment of networks by providing policy-driven plug-and-play provisioning and network bring-up operations.
C. It is used to design and simulate MPLS-TE and LSP routing.
D. It is used to design, provision, and monitor Label Discovery Protocol (LDP) and Border Gateway Protocol (BGP) services on devices
正解：A,B