Avaya 6006-1 問題集

質問 1：
In the function of processor Ethernet (PE) in a simplex S88XX primary is allowed for H.248 Gateway Registration.
What is H.248 gateway registration implemented in the S88XX Server using Processor Ethernet?
A. CM software automatically enables use of PE for H.248 Gateway registration through the CLAN interface so no other administrative procedure is required.
B. H.248 Registration is administered through the ip-interface procr form.
C. CM Software automatically enables use of PE for H.248 Gateway registration so no other administrative procedure is required.
D. H.248 registration is administered through the communication-interface-processor-channels form.
正解：B

質問 2：
A customer uses a S8510 server with a Media Gateway G650. No more circuit pack slots are left and the customer has already ordered and received the necessary components for adding additional DCP phones to the system, including a new G850.
Which three tasks need to be performed while installing the additional equipment?
(Choose three)
A. Remove the right TDM/LAN bus terminal from the bottom G850 carrier and install the bus terminator at the left end of the TDM/LAN bus on the G650 carrier directly above.
B. Add additional 2GB of RAM to the S8510 server.
C. Set the proper carrier address ID for the second G650 carrier.
D. The new digital line card must be installed din slot 2 of new G650
E. Cable the two G850 carries with a TDM/LAN Bus Extender cable.
正解：A,C,E

質問 3：
In an S8730 server configuration using software duplication, which Ethernet port is used as the duplication link?
A. Ethernet 1
B. Ethernet 3
C. Ethernet 0
D. Ethernet 2
正解：C

質問 4：
A technician wants to test and see if the voice channel between two IP phones is shuffled.
A command in Site Administration Terminal (SAT) can be used to determine the type of IP connection, and to check if the voice channel is shuffled?
A. Status shuffling <extension>
B. Status station <extension>
C. Test station <extension>
D. List station
正解：B

質問 5：
The G450 serves as a router as well as the endpoint for the WAN line.
Which physical interface is used to make the G450 a router?
A. ETH LAN
B. WAN Serial interface
C. ETH WAN
D. Loopback interface
正解：C

質問 6：
When administering a new Media Gateway, in which three locations is the name administered? (Choose three)
A. In the Gateway with the command 'set system name'
B. In the Gateway with the command 'set system config'
C. In Communication Manager with the command 'add Node-Names ip'
D. In Communication Manager with the command 'add Media-gateway [#]'
E. In the Gateway with the CLI command 'set system name'
正解：C,D,E

質問 7：
When configuring the LSP/SLS on Media Gateways, the gatekeeper information needs to be administered so that stations register to the gateway during a WAN outage.
How would this be accomplished?
A. In CM use the 'change station' command and input the node of the gateway for the field for 'Survivable GK Node Name'
B. In Cm administer the 'system-parameter mg-recovery-rule [#]' and identify the station.
C. In CM use the 'change station' command set 'Survivable COR' to Y.
D. In CM use the 'change station' command and set the field 'Survivable Trunk Dest'? to Y
正解：B