Avaya 3100.1 問題集

質問 1：
You are configuring Personal Station Access (PSA) and you configure the Communication Manager with the following settings:
-
Set TTI enabled = 'Y'
-
Set PSA Associated code = '25' and disassociate code '#25'
-
Set security code for the station = '1234'
You activate the station by keying in FAC for PSA, station extension number, '#', the security code of the station, and '#'. However, the station is not activated.
Which statement describes the issue to be addressed?
A. You did not key in the correct activation sequence
B. You need to set TTI = 'n'
C. You should not set the security code in sequential order.
D. You did not enable PSA on the COS of the station.
正解：D

質問 2：
Security Violation show valid and invalid attempts to access the system using three types of codes.
In addition to station security codes, which two types of codes are measured in security Violation reports? (Choose two)
A. Administrative login codes
B. Access security gateway (ASG) codes
C. Authorization codes
D. Barrier codes
E. Dial access codes (DAC)
正解：C,D

質問 3：
Which ASA main menu option displays the capacity of the Communication Manager?
A. Fault and Performance
B. General
C. Tasks
D. Advanced
正解：B

質問 4：
Which component registers SIP Endpoints?
A. Session Manager
B. System Manager
C. Communication Manager
D. Switch
正解：A
解説: (Topexam メンバーにのみ表示されます)

質問 5：
Which parameters must be configured to implement Automatic Route Selection (ARS)?
A. Dial Plan, Codec Set, Private Numbering, Network Region
B. Feature Access Code, Digit Analysis, Digit Conversion, Route Pattern, Trunk Group
C. Far-End Node, Near-End Node, Coverage Path, Call Forwarding
D. MGC List, H 2<18 Link Timer, Call Admission Control. Feature Access Code
正解：B

質問 6：
You are adding ten new IP telephones in a small company administered with a G430 Media Gateway and a S8300D ICC main server. The G430 has the S8300D inserted in the slot V1, and MM71 in the slot V2, and an MM712 in the slot V3.
Which hardware module will act as Gatekeeper for the telephones?
A. S8300D server using Processor Ethernet (PE)
B. MM712
C. MGP on the media gateway
D. MM710
正解：A

質問 7：
In Communication Manager, in which way are alarms classified?
A. By the number of times the alarms are recorded
B. As a function of their effect on the system's operation
C. Whether the alarms are on-board or off-board
D. By the number of errors that appear
正解：B
解説: (Topexam メンバーにのみ表示されます)